MS35206 pan-head machine screws.

// DIMENSION GUIDE

Machine-screw length and thread diameter

Schematic only; not to scale. Letter labels are keys for this illustration. Use the applicable part specification for dimensions, tolerances and measurement conventions.

// PART IDENTIFICATION

Pan head, cross recess and coarse thread

MS35206 identifies cadmium-plated steel, cross-recessed pan-head machine screws with UNC-2A threads. The raised pan head sits above its bearing surface.

Head style, drive, thread, material and finish all belong in the requirement.

// STOCKED SELECTION

Stocked MS35206 part numbers

Selected stocked configurations are listed below. Dimensions are nominal identification references in inches; use the controlling specification and drawing for full tolerances and acceptance requirements.

Stocked items are subject to prior sale. Request a quote to confirm current availability and lead time.

Rows marked patched identify a stocked modified configuration. Dimensions describe the base screw; confirm the patch specification and drawing before ordering.

// LENGTH AND MODIFICATIONS

Measure length beneath the head

For these pan-head screws, nominal length runs from the bearing surface beneath the head to the tip. MS35206-213 is a 4-40 by 1/4-inch selection; MS35206-228 is a 6-32 by 3/8-inch selection.

The NP ending in the stocked modified item is retained as an ordering identifier. Confirm its patch requirement against the controlling drawing rather than treating NP as a universal standard suffix.

// FAMILY COMPARISON

Compare the complete screw requirement

MS35207 is a related fine-thread family. MS51957 is a separate corrosion-resistant steel machine-screw family. A similar head or matching thread does not establish an approved alternate.

// STANDARD STATUS

Legacy document and purchasing reference

MS35206 was canceled on February 29, 2000 and names NASM35206 as its successor. Preserve the part designation and standard issue required by the drawing.